Troubleshooting; Problems In The Procedures For Updating; Messages In The Procedures For Updating - Pioneer T1000-19329 Upgrade Instructions And Operation Manual Addendum

Troubleshooting

Problems in the procedures for updating

Symptom
The upgrade process doesn't
start and the navigation system
boots up as usual.
The navigation system does not
work properly after upgrade.

Messages in the procedures for updating

The following messages may be displayed by your navigation system. Refer to the table below to
identify the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Message
An error occurred and the up-
date failed.
Cause
An incorrect microSD card has
been inserted.
Upgrade has been already done.
The screen that cannot begin the
upgrade process is displayed.
The engine of your vehicle was
stopped or the power supply to the
navigation system was turned off
during upgrade process.
Upgrade microSD card was pulled
out during upgrade process.
When
Unexpected error occurred in the
update process.
Action
Eject the inserted microSD card and insert
the correct upgrade microSD card.
Check whether the upgrade was done prop-
erly. If the upgrade has not been done yet,
consult the nearest authorised service sta-
tion.
Eject the upgrade microSD card, and display
the map of your current position, and then re-
insert the upgrade microSD card.
Consult the nearest authorised service sta-
tion.
Consult the nearest authorised service sta-
tion.
What to do
Consult your local Pioneer dealer if this mes-
sage persist.
Appendix
21
Engb