RAB SWISHFA -2X2 Instructions

INSTRUCTIONS
SWISH® FA INSTALLATION
RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi cient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We'd love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts inside.
CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened
rmly. Apply weatherproof silicone sealant around the edge of the ceiling mounting box and/or junction box. This is
especially important with an uneven ceiling surface. Silicone all plugs and unused conduit entries.
RECESSED CEILING MOUNTING
The fi xture is suitable only for INDOOR RECESSED CEILING
application. Above ceiling access required.
To mount in an insulated or non-insulated ceiling - 9/16" or 15/16"
exposed Flat Tee Grid Ceiling follow the steps below.
1. Rotate and slide the Housing as required to fi t through the
Tee-Grid Bar and place it as indicated by the directional arrow
as shown in Fig. 1.
2. Firmly bend the pre-installed Grid Clips (4) against the
Tee-Grid Bar to secure the Housing as shown in Fig. 2
3. Support wires are required by Installation Codes. Support the
Housing to the building structure by Support Wires (supplied by
others) through the Support Wire Hole as shown in Fig. 3.
4. Make sure that the orientation of the Access Plate faces an
accessible tile to make electrical splices.
5. Loosen screw on Access Plate and remove the Access Plate
(Fig. 1). Knock out appropriate Conduit Knockouts on the
Access Plate to route input conduit. Use appropriate conduit
connectors as required by code.
6. Connect wires as shown in wiring diagram (Fig 4). Push all
wires back into the Splice Box. Be careful not to pinch wires.
WARNING: To prevent wiring damage or abrasion, do not
expose wiring to edges of sheet metal or other
sharp objects.
7. Replace Access Plate and tighten Access Plate Screw.
8. After installation remove protective fi lm from the outer surface
of the lens.
SWISHFA -2X2 SWISHFA -2X4
Housing
Fig: 1
Fig: 2
Housing
Fig: 3
nominal 4"
Access Plate
Access Plate
Screw
Grid Clip
Tee-Grid
Bar
Support Wire
(supplied by others)
Conduit Knockouts
Grid Clips (4)
Tee-Grid Bar
Firmly bend Grid
Clips against the
Tee-Grid Bar
Support Wire
(supplied by others)
Support Wire Hole
Tee-Grid Bar