Download Print this page

WeatherTech WindshieldFone Instruction Sheet

Download this manual

Installation Video

Base

5" Medium Arm

3" Short Arm

Note: We recommend reading all instructions prior to beginning.

Step 1: Choosing the Length

Determine a safe, convenient location to mount on

your windshield. We recommend keeping it as low

on the windshield as possible.

Note the length between your windshield and the

front of your dashboard.

Contents: WindshieldFone, 3" Short Arm, 5" Medium Arm, Rubber Bumper

Telescopic Arm

Base Lever

Knob E

WindshieldFone

Knob D

Knob C

Start with the installed telescopic arm, and extend

or retract as necessary to see if it fits your dash. If

so, you're ready to mount. If the telescopic arm is

too long, you can easily swap it out with either the

included 3" Short or 5" Medium Arm.

The suction cup Base can be flipped to allow for

easier mounting.

Knob B

Holder

Knob A

Rubber Bumper

67WF1

Page 1 WindshieldFone Installation Video Contents: WindshieldFone, 3” Short Arm, 5” Medium Arm, Rubber Bumper Telescopic Arm Base Lever Knob D Knob C Knob B Base Holder Knob E Knob A 5” Medium Arm 3” Short Arm Rubber Bumper Note: We recommend reading all instructions prior to beginning.
Page 2 Position the swivel section of the Arm against the bolt head on the opposite side. Remove bolt, then screw on the rear of the WindshieldFone Holder, spread the base to remove the arm. Depending on then add and tighten Knob B until secure.
Page 3 Step 4: Mounting WindshieldFone Clean the windshield surface where you intend to Ensure the Lever on the Base is in the release adhere the suction cup, then let dry completely. position and that Knobs C and D are facing up.
Page 4 Quick Lock & Release tabs and press with your thumb until your phone pops out. Note: Please check state and local laws prior to use. LET’S TALK Made in USA 800-441-6287 or 630-769-1500 © 2022 MacNeil IP LLC For warranty information, please visit www.WeatherTech.com/warranty 67WF1...