Advertisement
Step 2: Adjusting the Attached Telescopic Arm
C
Loosen Knobs C and D until you can adjust the
telescopic arm to perfectly fit your dashboard.
When the dash allows, the Holder can sit over the
edge of it. Tighten Knobs C and D.
Step 3: Swapping out for Shorter Arms
E
First, loosen and remove Knob B, and remove
the WindshieldFone Holder. Then on the Base,
loosen and remove Knob E while securing the
bolt head on the opposite side. Remove bolt, then
spread the base to remove the arm. Depending on
placement, the base can also be flipped to ease
mounting.
G
Add the Base to the opposite end of the Arm at its
hinge.
D
To increase stability, add the Rubber Bumper to
the section of the telescopic arm that's closest to
the edge of the dashboard.
F
3" Short Arm
5" Medium Arm
Choose your preferred 3" Short Arm or the 5"
Medium Arm. Installation of both is easy:
Position the swivel section of the Arm against the
screw on the rear of the WindshieldFone Holder,
then add and tighten Knob B until secure.
H
Slide the bolt into the hinge, and while holding the
bolt head, add and tighten Knob E until secure.
© 2022 MacNeil IP LLC
67WF1
Advertisement
