Tripp Lite SmartOnline AG-0358 Series Owner's Manual page 18

Operations
8 Select UPS Battery Age Alert
Next, the UPS will prompt you to select the timing of the Battery
Age Alert notification. You can select between 12-60 months.
The factory default setting is Disabled.
Using the UP / DOWN
battery age alert in months, then press APPLY
9 Select Audible Alarm ENABLED / DISABLED status
Next, the UPS will prompt you to select the alarm ENABLED /
DISABLED status.
Using the UP / DOWN
DISABLED status, then press APPLY
Note: Disabling the alarm prevents the audible alarm from sounding
during power failures and UPS fault conditions only. The alarm will still
"chirp" to confirm operator input via the front panel LCD navigation
buttons when the alarm is set to disable.
The UPS will then go through a series of diagnostic checks before turning on output power. Once the UPS reports the operating status
of NORMAL / LOAD PROTECTED with the configured POWER STRATEGY enabled, your UPS can immediately be put into service to
provide reliable protection from a wide variety of power problems.
buttons, select the timing of the
.
buttons, select the alarm ENABLED /
.
Batt Age Alert
Months:36
Back Select Apply
ESC
8
Range: 12 to 60, Default: Disabled
Audible Alarm
Enabled
Disabled
Back Select Apply
ESC
9
18
SETUP
SETUP