Table of Contents
Advertisement
Chapter 7. Configuring the Network Port
packets. Lost packet counts are given in the S
Choices: D
Delay Measurement (PVC DELAY)
Set to E
When enabled, the TSU IQ+ periodically transmits a loopback
frame to the remote TSU IQ+ which is then returned to measure
round trip delay of each PVC. Minimum, maximum, and average
delay measurements are given in the S
Choices: E
Stats Option (STATS OPT)
This option prioritizes PVCs for S
tracks statistics for a limited number of the PVCs that pass through.
This number is determined in the M
Maximum PVC Count on page 7-5). The three choices for this field
are described below:
Auto
If set to A
PVC C
a PVC as second priority to a PVC set to E
Enabled
If set to E
M
designated as a higher priority than one set to A
Disabled
If set to D
any time.
If the TSU IQ+ encounters a PVC that has not been entered into the PVC
O
7-8
or E
ISABLED
only if there are TSU IQ+s on both ends of the PVC.
NABLE
or D
NABLE
ISABLE
, then statistics will be logged for this PVC if the M
UTO
has not been exceeded. The A
OUNT
, then statistics will be logged for this PVC if the
NABLED
PVC C
has not been exceeded. A PVC set to E
AX
OUNT
, then statistics will not be logged for this PVC at
ISABLED
table, the PVC is set to A
PTIONS
TSU IQ+ User Manual
.
NABLED
TATISTICS
.
TATISTICS
PVC C
AX
UTO
NABLED
by default.
UTO
menus.
TATISTICS
menus.
counts. The TSU IQ+
field (see
OUNT
selection designates
.
NABLED
.
UTO
61200275L1-1
AX
is
Advertisement
Table of Contents
