Read Community (Rd Community); Write Community (Wr Community); Trap Mgr Options (Trap Mgr Opts); Trap Manager Dlci (Trap Dlci) - ADTRAN TSU IQ+ User Manual

Read Community (RD COMMUNITY)

Enter the authentication strings used for SNMP management.
Match the TSU IQ+ to the SNMP manager for read privileges. If
using front panel entry, see the section Entering Letters Using the
Front Panel on page 9-6 for more information.

Write Community (WR COMMUNITY)

Enter the authentication strings used for SNMP management.
Match the TSU IQ+ to the SNMP manager for write privileges. If
using front panel entry, see the section Entering Letters Using the
Front Panel on page 9-6 for more information.

Trap Mgr Options (TRAP MGR OPTS)

The T
SNMP managers.

Trap Manager DLCI (TRAP DLCI)

If the T
parameter identifies the virtual circuit used for all traps generated
by the TSU IQ+.

Trap Manager IP (TRAP IP)

Enter the IP address of the SNMP manager to which the TSU IQ+
sends traps.

Trap Manager Port (TRAP PORT)

Enter the TSU IQ+ port used to transmit traps to the SNMP
manager.
Choices: N
ethernet port selection is available only if the ethernet card is
installed.)

Next (NEXT key on front panel)

Edit the next entry in theTrap Manager Options table.
61200275L1-1
M O
RAP ANAGER PTIONS
M P
RAP ANAGER ORT
, DTE P
ONE ORT
TSU IQ+ User Manual
Chapter 9. System Configuration
table defines routes for up to five
is set for N
ETWORK
; N P ; C
ETWORK ORT ONTROL
or DTE, this
P . (The
ORT
9-3