Table of Contents
Advertisement
Chapter 6. Data Port Configuration
DSX PORT
Configure these options to be compatible with the T1 service
provided and with the
shown in Figure 5-2 on page 5-3.
Framing Format (FRAMING)
Set the framing format of the
your T1 service. This information is available from your service
provider. Choices are D4 or ESF.
Line Code (LNE CODE)
Set the line coding of the
your T1 service. This information is available from your service
provider. Choices are B8ZS or AMI.
Yellow Alarm
E
Line Length (LBO)
Select the length of the
7.5dB. The unit can then calculate the proper output level for the
port. Choices are 0
533
In-Band Loopback (LOOPBACK)
E
loop-down codes (per ANSI T1.403 specifications) which may be
sent through the
Robbed Bit Signaling (ROBBED BIT)
Set R
connected to the
6-6
or D
the transmitting of yellow alarms.
NABLE
ISABLE
TO
655 and 7.5 dB.
TO
or D
the unit's ability to accept in-band loop-up or
NABLE
ISABLE
DSX-1
B
S
OBBED
IT
IGNALING
DSX-1
TSU IQ+ User Manual
port's connection. The menu tree is
DSX-1
interface to be compatible with
DSX-1
interface to be compatible with
DSX-1
's interface cable (in feet) or select
DSX-1
133; 133
266; 266
TO
interface. This loopback is a line loopback.
to match the settings of the device
port.
399; 399
533;
TO
TO
61200275L1-1
Advertisement
Table of Contents
