Zennio MAXinBOX 24 Technical Documentation

Multifunction actuator with 24 (16A) outputs
ZIO-MB24
FEATURES
▪ 6 configurable blocks:
o
Shutter channels (up to 12).
o
Individual outputs (up to 24).
o
2-pipe fan coil control (up to 6 fan coils).
▪ Manual output operation with push button and LED status indicator.
▪ Suitable for capacitive loads, maximum 140 μF.
▪ Possibility of connecting different phases in adjoining outputs.
▪ 30 logic functions.
▪ Total data saving on KNX bus failure.
▪ Integrated KNX BCU.
▪ Dimensions 69 x 96 x 210mm (12 DIN units).
▪ DIN rail mounting (EN 50022), through pressure.
▪
Conformity with the CE directives (CE-mark on the right side).
1. Output
5. Programming/Test button
Programming/test button: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe
mode. If this button is held for more than 3 seconds, the device enters the test mode.
Programming/Test LED: programming mode indicator (red). When the device enters the safe mode, it blinks (red) every half second. The manual
mode is indicated by the green color. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it starts a blue blinking
sequence.
GENERAL SPECIFICATIONS
CONCEPT
Type of device
Voltage (typical)
Voltage range
KNX
Maximum
supply
consumption
Connection type
External power supply
Operation temperature
Storage temperature
Operation humidity
Storage humidity
Complementary characteristics
Protection class
Operation type
Device action type
Electrical stress period
Degree of protection
Installation
Minimum clearances
Response on KNX bus failure
Response on KNX bus restart
Operation indicator
Weight
PCB CTI index
Housing material
(1)
Maximum consumption in the worst case scenario (KNX Fan-In model)
© Zennio Avance y Tecnología S.L.
2. Output status LED
DESCRIPTION
Electric operation control device
29VDC SELV
21...31VDC
Voltage
29VDC (typical)
(1)
24VDC
Typical bus connector TP1 for 0.80mm Ø rigid cable
Not required
0ºC to +45ºC
-20ºC to +55ºC
5 to 95% RH (no condensation)
5 to 95% RH (no condensation)
Class B
II
Continuous operation
Type 1
Long
IP20, clean environment
Independent device to be mounted inside electrical panels with DIN rail (EN 50022)
Not required
Data saving according to parameterization
Data recovery according to parameterization
The programming LED indicates programming mode (red) and test mode (green).
Each output LED indicates its status (green)
700g
175V
PC FR V0 halogen free
Edition 2
3. Output control button
6. Programming/Test LED
mA
3.92
10
Further information
MAXinBOX 24
Technical Documentation
1
2
3
4
Figure 1. MAXinBOX 24
4. Fixing clamp
7. KNX connector
mW
113.68
240
www.zennio.com
5 6 7
Page 1 / 2