Flush Mount Installation - Monte Carlo Fan Company 5HM52 D Series Owner's Manual

10
House
Black
White
Ground
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to White
(Neutral) wire from house. Connect Ground leads from
mounting bracket and downrod to Ground lead from
house. Refer to Safety Tips section of manual.
13
Next lift the cover ring and install knurled
nuts as shown. Tighten the knurled nuts
securely. The canopy should adjust for
any irregularity in the ceiling or Outlet
box.
15
Remove the 3 yoke screws with the
keyslot holes and save.
© 2011 Monte Carlo Fan Company
11
Fan
Blue
Black
White
Green
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the
other side of the outlet box.
Go to step
25 to finish
installation.
16
Pass leadwires and safety cable through
the canopy.
12
Lift Conopy allowing the 2 studs to
protrude through the canopy.
14
Remove the 2 yoke set screws as shown
above.
17
Remove side covers from canopy exposing
4 holes. 2 closed holes and 2 open "L"
shape holes.
4
Cover Ring

Flush Mount Installation

1/20/2012