USB. The Control Center software connects via the USB-C interface to the Factory-Link-SPE-M and provides information about link state and signal quality and allows direct PHY register access. Faults in the T1 connection can be detected using the Signal Quality Indicator and the Cable Diagnostics function allowing shortcut, open connection, and fault distance detection.
Intended Purpose and Disclaimer Disclaimer: The products sold by i-novative® GmbH are for development and testing purposes in automotive or industrial applications only. The product Factory-Link-SPE-M is not intended to be used in series application or series production. Warranty Exclusion: i-novative® GmbH does not take over any liability for defects associated with the product and installation of that product.
Connectors and Cables 100BASE-T1 IEC 63171-6 Connector 5.1.1 T1-Plug Specification 5.1.2 Pin Assignment Signal Remark Data P Data N SHD Shield Connector Housing 5.1.3 T1 Cable Recommendation For proper operation of the link, the used network cables and connectors for the T1 link must comply to the specifications of the respective standards.
The Auto Role Switch feature can increase the link setup time. 100BASE-TX Link At the Fast Ethernet (100BASE-TX) side (RJ45 port), the Factory-Link-SPE-M is configured for Auto- Negotiation and solely advertises full-duplex 100Mbit/s capability. INO_Factory-Link-SPE-M_User_Manual_V1.0.docx...
Software The graphical user interface is intended for remote monitoring. It can also be used for testing and development purposes as it provides direct access to the register sets of the integrated PHYs. It provides the following functions: Controller 100BASE-T1 connection 100BASE-TX connection •...
Controller Functions If you have attached multiple i-novative Media Converters to the same host via the USB configuration ® port, you can connect the UI to a specific one using the drop-down list. The Media Converters are distinguished by their type and USB serial number.
Device The values are preconfigured and be selected by right-clicking a respective field. 00: BroadR-Reach Registers access 1F: RDB Register access Register Is the PHY Register address relative to the block selected in the Device field. Entering a value and pressing ENTER or TAB will read the respective register. Represents a PHY register value that has been read entering the address data in the Value Device and Register fields.
VerpackVO). If you as a customer have problems with the disposal of packaging and shipping materials, please write an email to info@i-novative.de. Recycling Reference and RoHS Compliance Please note that parts of the products from i-novative GmbH ® must be properly recycled and must not be disposed with household waste (i.e.