Tx Functions - I-novative Factory-Link-SPE-M User Manual

Device The values are preconfigured and be selected by right-clicking a respective field.
00: BroadR-Reach Registers access
1F: RDB Register access
Register Is the PHY Register address relative to the block selected in the Device field. Entering
a value and pressing ENTER or TAB will read the respective register.
Represents a PHY register value that has been read entering the address data in the
Value
Device and Register fields. Entering a value in this field will result in a write operation
to the respective register. Written values are read back and displayed for a validation
of the write operation.
All entries are expected to be hexadecimal numbers.

TX Functions

7.3
The "legacy" Ethernet PHY supports Link State Monitoring and Register Access like the T1 PHY.
Please refer to the previous section for a description.
The used KSZ8081 PHY does not support Clause 45 MDIO addressing or indirect register addressing.
The Device address is set permanently to 0x00 and can be ignored.
INO_Factory-Link-SPE-M_User_Manual_V1.0.docx
2022-09-10 11 / 12