Installing Software - Microtek ScanMaker i800 Scanning Manual

2 ScanMaker i800 Pro Scanning Guide

Installing Software

Before scanning with ScanWizard Pro, make sure it has been installed correctly.
Follow the steps below for installation.
PC:
1. Place the Adobe CD-ROM into the CD-ROM drive, and install the software.
2. Place the Microtek ScanMaker i800 Pro CD-ROM into the CD-ROM drive, and
follow the on-screen instructions to install the driver and software.
Note: If the Microtek Software Installer screen does not come up automatically,
double-click the following in succession: "My Computer"; the CD-ROM icon; then
cdsetup.exe to start the installer program.
3. Restart your computer at the end of all software installation.
MAC:
1. Place the Adobe CD-ROM into the CD-ROM drive, and install the software.
2. Place the Microtek ScanMaker i800 Pro CD-ROM into the CD-ROM drive, and
double-click the ScanWizard Pro folder and installer icon.
Note: After rebooting your Macintosh, the Microtek software will attempt to locate
your scanner on the system. Since this is your first install and you may have not yet
connected the scanner, simply ignore the message that appears.