GE IC754VSI12CTD Operator Interface Products page 66

4
The QuickPanel View provides two methods for setting an IP address:

DHCP (Dynamic Host Configuration Protocol). There must be a
DHCP server on the connected network for a valid IP address to be
assigned. Contact your network administrator to ensure correct DHCP
server configuration.

Manual method. You uniquely specify the numeric addresses for the
QuickPanel View, the Subnet Mask, and the Default Gateway (if
applicable).
DHCP is the default on LAN1. The default on LAN2 is Manual with a setting of
IP address 192.0.0.1 subnet mask of 255.255.255.0 and no gateway.
Note:
To set an IP address
1. From the Control Panel, tap
The Connection window appears.
12" QuickPanel* View Intermediate, Color and Monochrome – December 2010
4-24
Use a crossover cable to connect the QuickPanel View directly
to a PC. When connecting to a LAN HUB, use a
straight-through cable. Contact your network administrator for
further information.
Network and Dial-up Connections.
GFK-2306E