Table of Contents
Advertisement
Ethernet
The QuickPanel View is equipped with one auto-negotiate, full or half duplex
Ethernet port (IEEE802.3). The auto-negotiate feature is not configurable on
the QuickPanel, therefore all devices on the network to which the QuickPanel is
attached should also be in auto-negotiate mode to ensure proper network
communications.
You can connect an Ethernet network cable (unshielded, twisted pair,
UTP CAT 5) to the unit via the RJ45 connector on the bottom of the enclosure.
LED indicators on the port indicate channel status. Access to the port is
possible either by Windows CE network communications, or by your custom
application. The following diagram shows the location, orientation, and pin out
of the Ethernet port.
Activity LED
(On: Packet received
or transmitted)
GFK-2306E
LAN1: 10/100Mb
Ethernet Port
Link LED
(On: Channel
connected OK)
Chapter 4 Detailed Operation
1
TX_D1 +
2
TX_D1 -
3
RX_D2 +
4
B1_D3+
5
B1_D3-
6
RX_D2 -
7
B1_D4+
8
B1_D4-
4
4-23
Advertisement
Table of Contents
