Microtek ScanMaker 3700 Supplementary Manual

LightLid 35 Calibrator
Overview
This consolidated PC/Mac guide describes the
function and operation of the LightLid 35
Calibrator for Windows and the LightLid 35
Calibrator for Macintosh.
tools are applicable to Microtek scanners that
use the LightLid35 (LL35) transparent media
adapter (TMA) for scanning transparency slides
and film.
Launching LightLid 35 Calibrator
Launch the LightLid 35 Calibrator by clicking on the calibrator file icon. (Note:
For Windows, the calibrator icon default location is in the same folder where your
ScanWizard 5 is located. For Macintosh, locate the icon from your defined
folder.) Then follow the calibration instructions as shown in the LightLid 35
Calibrator window below (sample figure is from Windows, which is identical to
that of the Macintosh except for the title bar).
NOTE
calibration tool, be sure that
ScanWizard 5 is already
installed on your system and
your scanner is powered up.
For optimum results, place the
adapter in such a way that the
adapter's front edge is pressed
against the front glass frame of
scanner and is centered
Copyright© 1999 Microtek International Inc.
These calibration
Before launching the
horizontally.
http://www.microtek.com
Installation
Insert the Microtek CD-ROM into your CD-
ROM drive, then look for LightLid 35
Calibrator tool in the folder "
Open the folder and click on the setup icon.
Then follow the instructions for installation as
they appear on screen.
Click "Calibrate" button
to start calibration
I49-002669A, September 1999
"
LL35cali.