No Sound; Unstable Image Displayed By Vhs (Video Player); No Response With Remote Control - Microtek VX2 User Manual

No Sound

Unstable Image Displayed by VHS (Video Player)

No response with remote control

When using the remote control, please take note that if the button on the remote
control is pressed, this can result in continuous release of power and cause great
power consumption.
ＶＸ２．ｐ６５
If a video image is being displayed, you may adjust the color
intensity and tint settings on the VIDEO menu.
Check whether the audio output is in the Mute status. Press
the MUTE button on the operation panel.
Check to ensure that the volume is not turned all the way
down.
Check to ensure that the RCA Cable (Audio) is connected
securely to the Audio source and the projector.
Check to ensure that a wrong source has not been selected.
If so, press the SOURCE button on the operation panel or on
the remote control for a right selection.
This is normal because the input signal from a VHS is
unstable. Users are suggested to use S-video or component
input instead, if possible. Check to ensure that an extra-long
S-video cable is not being used.
Check if the battery has run out of power, or replace with new
batteries.
48 02-10-18, 11:05