Table of Contents
Advertisement
AXIS C1610-VE Network Sound Projector
Additional settings
Set up rules for events
You can create rules to make your device perform actions when certain events occur. A rule consists of conditions and actions. The
conditions can be used to trigger the actions. For example, the device can play an audio clip according to a schedule or when it
receives a call, or send an email if the device changes IP address.
To learn more, check out our guide Get started with rules for events.
Send an email if a speaker test fails
In this example the audio device is configured to send an email to a defined recipient when a speaker test fails. The speaker test
is configured to be performed 18:00 every day.
1. Set up a schedule for the speaker test:
1.1
Go to the device interface > System > Events > Schedules.
1.2
Create a schedule that starts at 18:00 and ends at 18:01 every day. Name it "Daily at 6pm".
2. Create an email recipient:
2.1
Go to the device interface > System > Events > Recipients.
2.2
Click Add recipient.
2.3
Name the recipient "Speaker test recipients"
2.4 Under Type, select Email.
2.5
Under Send email to, enter the email addresses of the recipients. Use commas to separate multiple addresses.
2.6
Enter the details for the email account of the sender.
2.7
Click Test to send a test email.
Note
Some email providers have security filters that prevent users from receiving or viewing large attachments, from
receiving scheduled emails and similar. Check the email provider's security policy to avoid delivery problems and
locked email accounts.
2.8 Click Save.
3. Set up the automated speaker test:
3.1
Go to the device interface > System > Events > Rules.
3.2
Click Add a rule.
3.3
Enter a name for the rule.
3.4 Under Condition, select Schedule and select from the trigger list
3.5
Under Schedule, select your schedule ("Daily at 6pm").
3.6
Under Action, select Run automatic speaker test.
3.7 Click Save.
4. Set up the condition for sending an email when the speaker test fails:
4.1
Go to the device interface > System > Events > Rules.
4.2
Click Add a rule.
8
Advertisement
Table of Contents
