Table of Contents
Advertisement
AXIS C1610-VE Network Sound Projector
The device interface
Speaker test
You can use the speaker test to verify from a remote location that the speaker works as intended.
Calibrate: Click to calibrate the speaker before you test it for the first time. During calibration, the speaker plays a series
of test tones that are registered by the built-in microphone. When you calibrate the speaker, it must be installed in it's final
position. If you move the speaker later on, or if it's surroundings change, for example if a wall is built or removed, you need
to recalibrate the speaker.
Run the test: Click to play the same series of test tones that were played during calibration, and compare them with the
registered values from the calibration.
Recordings
Click to filter the recordings.
From: Show recordings done after a certain point in time.
To: Show recordings up until a certain point in time.
Source
: Show recordings based on source.
Event: Show recordings based on events.
Storage: Show recordings based on storage type.
Ongoing recordings: Show all ongoing recordings on the camera.
Select to start a recording on the camera.
Choose which storage device to save to.
Select to stop a recording on the camera.
Triggered recordings will end both when manually stopped and when the camera is shut down.
Continuous recordings will continue until manually stopped. Even if the camera is shut down, the recording will continue
when the camera starts up again.
Click to play the recording.
17
Advertisement
Table of Contents
