Table of Contents
Advertisement
3. Take-up thread guide
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the following
work after turning the power off and ascertaining that the motor is at rest.
A
C
❷
D
B
If you want to change the feed amount of thread fed
from the thread take-up lever, loosen the setscrew of
take-up thread guide ❷ and move take-up thread guide
❷ appropriately.
Move the take-up thread guide in direction A to de-
crease the thread feed amount.
Move the take-up thread guide in direction B to in-
crease the thread feed amount.
❶
* Standard position of the take-up thread guide
The position where take-up thread guide ❷ is at its
lower end while the setscrew is fitted in the upper
tapped hole (C) in the thread guide mounting plate ❶
(See the figure on the left.)
If you want to move the take-up thread guide in direc-
tion B from its standard position, insert the setscrew of
take-up thread guide ❷ into the lower tapped hole (D)
in thread guide mounting plate ❶ .
– 3 –
Advertisement
Table of Contents
