Table of Contents
Advertisement
Correction value
6)
7)
8)
Angle display
– 13 –
Enter a correction value on the operation panel
so that the angle you have checked in Step 3
becomes "0" (zero) or "360".
For example, enter "-5" if the angle you have
checked in Step 3 is "5". Enter "8" if the angle
you have checked is "352".
Press
to confirm the value you have
entered.
Enter the "Hook timing adjustment mode".
Check that the angle "0" (zero) is displayed
when the needle bar is at its upper dead point.
Advertisement
Table of Contents
