Tsw1100; Adc Performance With Clock Through Onboard Vcxo, Cdce72010 Configured For Differential Lvpecl Output - Texas Instruments ADS62P EVM Series User Manual

Connecting to FPGA Platforms
4.1.3 Test Result With Onboard VCXO and Differential LVPECL Clock
For the same setup as explained in the previous section, when Clock Option 3
FFT was captured as shown in
Option 3. That is why Option 2 (clock with crystal filter) is recommended over the differential LVPECL
output.
Figure 12. ADC Performance With Clock Through Onboard VCXO,
4.2

TSW1100

When the ADS62PXX is configured in CMOS output mode users can use TI's
Several additional board configuration steps are required before using this option.
• Remove resistor packs with the following reference designators: RN7, RN8, RN9, RN10, RN11, RN12,
RN13 and RN14.
• Install TI's SN74AVC16244 buffer into U12 and U13.
• If using the parallel interface mode (JP11=1-2), configure the ADC in CMOS output mode using the
silkscreen on JP14.
24 ADS62PXXEVM
Figure 12. The test results with Clock Option 2 are better than with Clock
CDCE72010 Configured for Differential LVPECL Output
www.ti.com
(Table 7) was used, the
TSW1100 capture board.
SLAU237A – May 2008 – Revised April 2009
Submit Documentation Feedback