Wall Mounting - Sony SLS-1A Manual

Wall Mounting

• Before mounting the speakers on a wall, follow the
steps in "Joining Multiple Speakers Together" to
have them ready for wall mounting. (page 11)
• Mount the speakers securely on a wall while giving
adequate attention to safety matters.
Sony assumes no liability for accidents and/or
damage you may suffer as a result of inadequate
mounting, insufficient mounting strength, improper
use, natural disasters, etc.
• You can paint the speaker grille and/or the speaker
enclosure as well. (page 19)
1
Choose a mounting location on a wall.
2
Attach the wall mounting bracket on the
wall with wood screws (commercially
available) or equivalents.
Hint
• Use a level to attach the wall mounting bracket so that
the bracket comes horizontal to the earth.
• The hole indicated by "a" in the following figure is
located at the middle point along the longer edge of
the wall mounting bracket. Use this hole as a reference
for attachment.
• For wall mounting, use screws with the diameter of
6 mm - 8 mm ( 1 / in - 11
4
washers with the outside diameter of 18 mm (
• When wiring cables, do it along the cutout (  ) side of
the wall mount bracket.
For horizontal installation
Use the above figure as a reference for
attachment.
For vertical installation
The orientation of the wall mounting bracket is
not relevant.
/ in) or equivalent and flat
32
23 / in).
32

a
3
For installing multiple speakers that are
joined together, use the metal joint fitting
for wall mounting brackets to join the wall
mounting brackets together.
Align the metal joint fitting with the wall mounting
bracket using the dowels and dowel holes on
them as reference points for positioning (  ), and
then secure them together with 4×10 screws with
washers.
Tightening torque: 2.0 N·m
Follow the instructions in step 2 and attach the
joined wall mounting brackets to the wall.
4
Fasten the shoulder screws to the wall
mounting bracket and adhere the spacer
pads.
Tightening torque: 2.0 N·m
For horizontal installation
Shoulder screws: Secure each to the location
indicated by "H" (  ).
Spacer pads: Adhere the square ones to the two
locations at the left and right ends of the wall
mounting bracket.



17
GB