Sony SLS-1A Manual page 34

Approach 4: Using the speakers in combination with an AV receiver or a projector at home
Connect the speakers with analog audio devices using the 3-pin Euro type terminal block headers.
Connect the speakers with an AV receiver (  ) or equivalent that has a home projector (  ) or a subwoofer (  )
connected.
You can place the speakers in the center, front, and rear, and then distribute audio input from the AV receiver to the
speakers.

Configuration
1
Perform a sound simulation with EASE Focus 3 and FIRmaker 3D.
• You can also set up the beam control by using the Line-Array Speaker Manager application without performing
a sound simulation.
• EASE Focus 3 and FIRmaker 3D can be downloaded from the website of AFMG Technologies GmbH at:
https://www.afmg.eu/en
• EASE Focus 3 data for the speaker can be downloaded from the website at:
https://pro.sony/products/professional-speakers/SLS-1A
2
Join the speakers together (page 11).
3
Connect the speakers with an AV receiver that has a built-in pre out terminals.
4
Connect the speakers to AC outlets with the power cords.
5
Mount the speakers on a wall (page 17).
6
Set up the speakers with the Line-Array Speaker Manager application (page 15). In addition, make
appropriate settings, as needed, on the AV receiver.
10
GB

