Advertisement
Mounting I Montage II
MoHTa>K
I
BcraHoaneH~
Before mounting
A depth of at least 72 mm {2
7
/a in)*
1
/44 mm
(1
3
/4
in)*
2
is required for flush mounting.
Measure the depth of the area where you are
to mount the speaker, and ensure that the
speaker is not obstructing any other
components of the car. Keep the followings in
mind when choosing a mounting location:
• Make sure that nothing is obstructing
around the mounting location of the door
(front or rear) or the rear tray where you are
to mount the speaker.
• A hole for mounting may already be cut out
of the inner panel of the door {front or rear)
or the rear tray. In this case, you need to
modify the board only.
• If you are to mount this speaker system in
the door {front or rear), make sure that the
speaker terminals, frame or magnet do not
interfere with any inner parts, such as the
window mechanism in the door {when you
open or close the window), etc.
Also make sure that the speaker grille does
not touch any inner fittings, such as the
window cranks, door handles, arm rests,
door pockets, lamps or seats etc.
• If you are to mount this speaker system in
the rear tray, make sure that the speaker
terminals, frame or magnet do not touch any
inner parts of the car, such as the torsion bar
springs {when you open or close the trunk
lid), etc.
Also make sure that the speaker grille does
not touch any inner fittings, such as seat
belts, head rests, center brake lights, inner
covers of the rear wipers, curtains or air
purifiers, etc.
Advertisement
