Modifying The Angle Of The Bar Speaker; Mounting The Bar Speaker On A Wall - Sony HT-NT3 Operating Instructions Manual

 [5.2GHz], [5.8GHz]: The system
transmits sound according to the
selected frequency band.
Tip
We recommend you to set [RF Band] to
[Auto].
Modifying the angle of
the Bar Speaker
You can modify the angle of the Bar
Speaker by attaching the supplied
stands to the bottom of the Bar Speaker.
Tip
When you place the Bar Speaker in a flat
position above eye level, detaching the
stands will ensure proper sound
orientation.
1
Turn the Bar Speaker upside
down.
2
Remove the protection sheet from
the double-sided tape on the
stand (supplied).
3
Attach the stand to the Bar
Speaker by matching the "" on
the stand to the "" on the Bar
Speaker.
4
Repeat step 2 and 3 to attach the
stand for the other side.
Mounting the Bar
Speaker on a wall
You can mount the Bar Speaker on a
wall.
Note

Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely to two studs in the wall beam.
Install the Bar Speaker horizontally, hung
by screws in studs in a continuous flat
section of the wall.

Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during the
installation.

Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.

When you use the HDMI IN 3 jack of the
wall-mounted Bar Speaker, connect the
swivel-type High Speed HDMI cable.
Stand
35
GB