Safety And Regulatory Information; Warning - Metcal RSS-1000-CVSI-NC User Manual

USER MANUAL, RSS-1000-CVSI

SAFETY AND REGULATORY INFORMATION

WARNING

 IN ORDER TO BE IN COMPLIANCE WITH REQUIREMENTS OF CE DIRECTIVES, THE
ROBOTIC SOLDERING SYSTEM MUST BE EQUIPPED WITH THE AC-RSS-1KSC SAFETY
COVER ACCESSORY. THE SAFETY INTERLOCK OF THE ENCLOSURE WILL
AUTOMATICALLY CEASE ALL MOVEMENT AND HOME THE SYSTEM ONCE AN
OPERATOR COMES IN CLOSE PROXIMITY OF THE WORKING ENVELOPE.
 THIS PRODUCT IS HIGH VOLTAGE! MAKE SAFETY THE NUMBER ONE PRIORITY
WHEN OPERATING THIS UNIT.
 TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE SYSTEM TO MOISTURE OR
OPERATE UNIT WITH WET HANDS.
 TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE FLAMMABLE SOLVENTS NEAR
OR ON THE SYSTEM WHILE CONNECTED TO A POWER SOURCE.
 FAMILIARIZE ONESELF WITH EMERGENCY STOP BUTTON'S LOCATION AND HOW TO
USE IT.
 TO PREVENT POSSIBILITY OF INJURY OR DAMAGE TO THE SYSTEM:
o DO NOT USE THE UNIT IF THERE ARE ANY VISIBLE BROKEN OR DAMAGED
WIRES/CABLES.
o DO NOT OPERATE WITH ANY COVERS OR PANELS REMOVED.
o DO NOT MOVE THE ROBOT IN ANY AXES BY HAND
o ALWAYS USE THE SILICONE REMOVAL PAD WHEN CHANGING OUT
CARTRIDGES
o ALWAYS CHECK FOR AND REMOVE OBSTRUCTIONS FROM THE WORKING
ENVELOPE OF THE ROBOT
o ALWAYS USE THE ROBOT WITHIN THE STANDARD REQUIREMENTS (SUCH AS
VOLTAGE, AIR PRESSURE, POWER FREQUENCY, ETC.) AS DETAILED IN THE
SPECIFICATIONS ON PAGE 9
 CHANGES OR MODIFICATIONS MADE TO THIS PRODUCT WITHOUT EXPRESS
CONSENT FROM OK INTERNATIONAL WILL VOID THE USERS AUTHORITY TO
OPERATE THE EQUIPMENT.
 DO NOT PLACE ANY MAGNETS ON THE CONTROLLER BOX OF THE ROBOT, AS THIS
WILL PRODUCE UNDESIREABLE EFFECTS ON THE SYSTEM
 Read and understand the entire User's Manual before installation or operation of the Robotic
Soldering System. Heed ALL warnings on the system and in the operating instructions.
 The Robotic Soldering System is only for point to point and line soldering of printed circuit
board assemblies. If you are not familiar with the proper and safe operation of the unit, do not
operate it until properly trained.
 Operate the unit from the type of power source indicated on the serial number label.
 Use only the supplied power cord. Avoid damage to the power cord. If damage should occur,
replace it with the approved OK International replacement power cord.
 This CAUTION symbol on the equipment refers the user to the user guide for additional
important information. This symbol appears next to the relevant information in the manual.
 This HOT symbol on the equipment warns the user of a hot surface and potential injury if
touched. This symbol appears next to the relevant information in the manual.
7000-5970
7 396
page of
A
Rev.