XTline XT102800 Original Instruction Manual page 60

In addition, the trigger serves as an instantaneous speed control. The more you press the
trigger, the faster the drill chuck will rotate, and vice versa. In addition, the drill is equipped with
an electronic brake, so the moment you release the trigger, the chuck will automatically stop with
a slight delay.
CHUCK
The chuck (2) is used for clamping various work tools and accessories. The advantage of the
keyless chuck is the ability to clamp tools without the use of special wrenches or other tools.
Rotate the chuck to the right (counterclockwise) to expand the chuck jaws (1). Turn the chuck
further until there is enough space between the jaws to insert the tool (drill bit, driver bit, bit
holder, etc.).
Insert the tool and turn the chuck back to the left (clockwise) to secure it until you feel a slight
resistance - then tighten firmly.
TIP!
Even if you tighten the tool in the chuck fully and with considerable force, it is still not
•
locked and may theoretically come loose during operation. To lock the tool in the chuck,
turn it counterclockwise and tighten until you hear a characteristic "clicking sound".
Tighten the chuck as far as it will go and then turn it slightly back rotating to the other
side until you clearly hear one particular "click sound". The tool is now locked in the
chuck and the drill is fully ready for operation.
HANDLE
The handle is rubberized and ergonomically shaped and serves for a firm grip of the drill. Hold
the drill firmly during operation and, if necessary, hold it with both hands.
Caution! Avoid covering the ventilation slots with your hand during the operation as this may
cause the unit to overheat.