Advertisement
The Modular network TAP is ideal for 10/100/1000MB copper network monitoring. The innovative design
allows this TAP to be easily installed into any copper 10/100/1000 network segment. Once installed in
your network the 10/100/1000 network TAP will enable you to monitor your network segments quickly and
effectively using a network analyzer, security devices, or any monitoring tool. This 10/100/1000 copper
TAP allows you to capture full-duplex traffic without dropping any packets.
Traffic Flow
The copper 10/100/1000 copper taps provide a copy of the directional traffic out each monitoring port.
Monitor Port C provides you a copy of the A -> B traffic
Monitor Port D provides you a copy of the B -> A traffic
M1GCCB Modular TAP KEY FEATURES
-
Small form factor – can fit 4 TAPs in a 1U and 12 TAPs in a 2U form factor
-
Four (4) Copper RJ-45 Ports
-
Link Speed Synchronization
-
Captures Full Duplex Traffic up to 2 Gigabits without dropping any packets
-
Supports Jumbo Frames
-
Passes physical layer errors
Garland Technology | 716.242.8500 | garlandtechnology.com/support
Copyright © 2021 Garland Technology, LLC. All rights reserved.
M1GCCB Quick Start Guide
QUICK START GUIDE
Breakout Network TAP | M1GCCB
1
Advertisement
Table of Contents
Related Manuals for Garland M1GCCB
Summary of Contents for Garland M1GCCB
- Page 1 Four (4) Copper RJ-45 Ports Link Speed Synchronization Captures Full Duplex Traffic up to 2 Gigabits without dropping any packets Supports Jumbo Frames Passes physical layer errors Garland Technology | 716.242.8500 | garlandtechnology.com/support Copyright © 2021 Garland Technology, LLC. All rights reserved.
- Page 2 Note: Network Cables MDI/MDIX determines direction of monitor output port Please take notice, the M1GCCB is only manageable via the DIP switches. DIP switch 8 must be in the off position even if it is inserted into a managed chassis (M1GxACS)
- Page 3 Synchronization Mode: DIP Switch 1 and 2 in OFF position. When in Synchronization Mode, all ports of the M1GCCB TAP are Auto MDI/MDIX, Auto Speed and Auto Duplex automatically. The TAP will synchronize to determine the highest supported network speed, drop link across all ports, and then only advertise and link to the highest supported common speed on all ports.
- Page 4 LNK (Link/Activity): Solid when link is achieved and flashes when Ethernet activity is detected on a particular interface. For questions, please contact Garland Technology Support at: 8AM-9PM (CST) Monday - Friday (Except for observed US Holidays) Tel: 716.242.8500 Online: www.garlandtechnology.com/support Garland Technology | 716.242.8500 | garlandtechnology.com/support Copyright © 2021 Garland Technology, LLC. All rights reserved.
Need help?
Do you have a question about the M1GCCB and is the answer not in the manual?
Questions and answers