Advertisement
2. Copy the new monitor-and-boot-image file to the interface module(s). Enter one of the following commands at
the Privileged EXEC level of the CLI:
Table 2: New Command Syntax for Upgrading the Monitor and Boot Images
a
Command Syntax
copy tftp lp <ip-addr> <image-name> monitor copy-boot all | <slot-number>
copy slot1 | slot2 lp <image-name> monitor copy-boot all | <slot-number>
a.These commands are supported in software releases 02.0.00 and later.
For software version 02.1.00c, the "image-name" filename is "lb02100c.bin".
Note: If you copy the new monitor-and-boot image to all interface modules using the all keyword, the management
module makes a copy of the image (called lp-monitor-0) and stores it in its code flash. If you copy the new monitor-
and-boot image to a specified chassis slot, the management module does not make a copy of the image.
3. Verify that the new monitor and boot images were successfully copied to flash by using the show flash
command. Check for the monitor image, boot image, and the date and time at which the new images were built.
D. Upgrading the Interface Module's ProCurve Software Image
To upgrade the ProCurve software image (primary or secondary) on all interface modules or an interface module in
a specified chassis slot, perform the following steps:
1. Place the new ProCurve software image on a TFTP server to which the system has access or on a PCMCIA
flash card inserted in slot 1 or 2.
2. Copy the new ProCurve software image from the TFTP server or a flash card in slot 1 or 2 to all interface
modules or an interface module in a specified chassis slot. To perform this step, enter one of the following
commands at the Privileged EXEC level of the CLI:
•
copy tftp lp <ip-addr> <image-name> primary | secondary all | <chassis-slot-number>
•
copy slot1 | slot2 lp <image-name> primary | secondary all | <chassis-slot-number>
For software version 02.1.00c, the "image-name" filename is "lp02100c.bin".
on the Interface Module
Description
Copies the "image-
name" file from a TFTP
server at "ip-addr" to all
interface modules or to
the specified interface
module (slot-number),
placing it as both the
monitor file in code
flash and the boot file in
boot flash.
Copies the "image-
name" file from a flash
card in slot 1 or 2 to all
interface modules or to
the specified interface
module (slot-number),
placing it as both the
monitor file in code
flash and the boot file in
boot flash.
5
Advertisement
