ProCurve 9408sl Quick Start Manual page 10

2. Install file mpr02100c.bin to MP primary flash.
3. Install file lb02100c.bin to all LPs in both the monitor area, and also boot flash.
4. Install file lp02100c.bin to all LPs in the primary flash area.
5. Install FPGA file pbif02100c.bin to all LPs.
6. Install FPGA file xtm02100c.bin to all LPs.
7. Install FPGA file xpp02100c.bin to all LPs.
8. Install FPGA file xbridge02100c.bin to all LPs (error messages will indicate the slots that do not have 60-
port modules, and therefore do not need or accept the XBRIDGE image).
After the script completes, use the show flash command to verify successful transfer of boot image, monitor image,
and primary software image. (There is no command to verify successful FPGA file transfer until after the interface
modules have been power-cycled.)
Then use this command to reboot the management module (which will cause a power-cycle of the interface modules),
specifying primary to correspond with where the script placed the new software images:
• boot system flash primary
# Filename: 9408sl-Script-02100c-TFTP.txt
#
# Sample 9408sl install script for 02.1.00c.
#
# This version uses TFTP to install these
# images: boot-and-monitor, pri flash, FPGAs.
#
# CHANGES NEEDED TO USE THIS:
# 1) change IP address to be your TFTP server
#
# NOTES:
# i. Script must be stored in
# same directory as image files.
# ii. If any line fails, script aborts!
# Users MUST verify results!
# iii. After files are installed, 9408sl must be
# rebooted for the upgrade to take effect.
#
# SYNTAX:
# copy tftp system <ip-addr> <script-filename>
#
SRC:tftp:10.10.10.56;
MP_MON:mb02100c.bin:boot;
MP_APP:pri:mpr02100c.bin;
LP_MON:all:lb02100c.bin:boot;
LP_APP:pri:all:lp02100c.bin;
PBIF:all:pbif02100c.bin;
XTM:all:xtm02100c.bin;
XPP:all:xpp02100c.bin;
XBRIDGE:all:xbridge02100c.bin;
10