Figure 3 Removing A Reflector - Federal Signal Corporation Spectralux Rear ILS Light Bar Installation Maintenance And Service Manual

Figure 3 Removing a reflector

REMOVAL:
➀
PRESS THE ROUND TABS FROM
BENEATH THE PCB AND SLIDE
THE REFLECTOR BACK.
➁
LIFT THE REAR OF THE
REFLECTOR TO REMOVE IT.
INSTALLATION:
➂
INSERT THE FRONT HOOKS IN
THE PCB.
➃
BRING THE REAR OF THE REFLECTOR
DOWN ON THE PCB AND INSERT THE
REAR HOOKS INTO THE PCB.
➄
SLIDE THE REFECTOR FOWARD
UNTIL IT SNAPS INTO PLACE.
4. Lift the rear of the reflector away from the PCB and remove it.
5. To install the new reflector, insert its front hooks into their slots on the PCB.
6. Bring the rear of the reflector down to insert its rear hooks through the PCB.
7. When the reflector rests on the PCB, make sure the rear hooks are fully inserted and
slide the reflector forward until its tabs snap into place.
8. Install the PCBs as described in steps 4 through 7 in "Replacing a PCB" on
page 13.
Installation, Maintenance, and Service Manual
Federal Signal www.fedsig.com
➀
R E
➀
➃
➄
➂
Servicing the Rear ILS
➁
S
O K
H O
A R
290A7045
15