Powering The Access Point - Cisco Catalyst 9124AX Series Hardware Installation Manual

Powering the Access Point

Figure 47: Position of the Ground Pad on the Right Side of the AP
1 Ground pad, where the ground strap screw holes are located.
Powering the Access Point
The AP supports these power sources:
• DC power – 24–56 VDC
• Power-over-Ethernet (PoE)
The AP can be powered via the PoE input from an inline power injector or a suitably powered switch port.
Depending on the configuration and regulatory domain, the required power for full operation is 802.3bt or
UPOE.
Note
The supporting outdoor power injectors are AIR-PWRINJ-60RGD1 and AIR-PWRINJ-60RGD2 rated at 60W
each. These power injectors support 10/100/1000BASE-T operation only. They do not support the 2.5GBAST-T
(mGig) Ethernet speed.
Table 11: Cisco Catalyst 9124AX AP Reduced Power Feature Matrix
SKU
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
50
PoE-in/DC Radio 0 dBm Radio
Input 1
SS Per SS
Path
dBm AUX Ethernetm
Radio Gig
Per
Path
Installation Overview
SPF GbE PoE-out Notes
Module PHY