Articulating Mount For The Ap To A Pole; Articulating Mount For The Ap To A Pole, On Page - Cisco Catalyst 9124AX Series Hardware Installation Manual

Installation Overview
Step 6
Using the 90 mm M8 long screw and the hardware supplied with the pivoting bracket, bolt the AP and bracket
plate to the wall plate mounted on the wall. See
this assembly. Do not fully tighten the assembly.
Note
Step 7
Pivot the AP as required, and then fully tighten the 90 mm M8 long screw using a 13–mm wrench.
Step 8 Proceed with installing antennas (only for external antenna models), connecting the data cables, grounding
the AP, powering, and configuring the AP.

Articulating Mount for the AP to a Pole

The optional articulating mounting kit AIR-MNT-ART1= contains a pivoting mounting bracket for both wall
and pole mounting. This kit can be used to install the AP on a pole or mast. It supports metal, wood, or
fiberglass poles from 2 to 5 inch (51 to 127mm) in diameter.
The AIR-MNT-ART1= articulating mounting kit allows for adjusting the AP position by pivoting the AP
along its vertical plane.
Figure 33: AP Pole Mounted Using the Pivoting Mounting Bracket
1
2
The AP should be mounted with the status LED on the base facing downwards.
One of four mounting holes for mounting the
AP to the bracket
Slots for band clamps
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
Articulating Mount for the AP to a Pole
Figure 30: Pivoting Wall Mounting Bracket , on page 34
3 Steel band clamps
4 Pole
for
37