Advertisement
Quick Links
Advertisement
Related Manuals for KAYO MOTO AU150
Summary of Contents for KAYO MOTO AU150
- Page 1 KAYO MOTO AU150 Assembly Manual WWW.KAYOMOTO.COM...
- Page 3 ① Torque wrench ② Additional rod for electric wrench socket ③ Needle nose pliers ④ 27mm socket ⑤ 14mm socket ⑥ 12mm socket ⑦ 8mm hexagon socket ⑧ 6mm hexagon socket ⑨ No. 12-14 wrench ⑩ No. 10-12 wrench ⑪ No. 10 T-socket ⑫...
- Page 4 4. The parts shown above need to be subsequently installed on the vehicle.
- Page 5 Name Quantity A User’s manual B Air pressure gauge C Spark plug socket D Rear axle slotted nut hardware M18*1.5 cotter pin 4*28 dust cap washer Φ18.5*53*2 spring washer Φ18*27*4.5 E Steering pull slotted nut The picture shows the details of the rod hardware washer hardware in the accessory box...
- Page 6 8. Use tool ⑫ to tighten the gear indicator 9. Use tool ⑫ to install the combination switch screw (S). 11. Put the vehicle on the stand for easy installation of other accessories. 10. Use tool ⑨⑩ to remove the fixing screws of the iron frame.
- Page 7 12. Install slotted nut and washer(E) of steering 13. Use tool ⑫ to install the hardware of front & pull rod, use tool ①⑭ to tighten, and insert the rear side plastics(M)(N) and tighten them. cotter pin(E), the bending angle is greater than 180°.
- Page 8 bumper (T) (torque requirement is 25-30N.m) and use ⑫ to install the front bumper plastics cover. 16. Install the sub-frame, use tool ①⑥ to 17. Use tools ①⑥ to tighten the bolt on rear rack tighten the sub-frame bolt(Q). (torque (O).
- Page 9 21. Install the front wheel on the front hub, and use tool ⑤⑪ to tighten and fix front rim lock nut(P) (torque requirement) 60-68N. m) 20. Please refer to user’s manual (A) for air pressure requirements. Use compressed air to inflate the tires and use the air pressure gauge (B) to inflate to the standard value of 5psi.
- Page 10 25. Pull the latch as above shown and remove 24. Take out the battery, according to the user’s the seat cushion, waiting for the subsequent manual, first tear off the seal on the battery, add installation of the battery electrolyte, then install the battery cover, and wait for the subsequent installation into the battery box.
- Page 11 29.Please read the user’s manual (A) carefully 28. Unscrew the fuel tank cap, add gasoline, before riding to better understand the performance and tighten the fuel tank cap clockwise. of the vehicle.