Mercedes-Benz EQE 350+ Owner's Manual page 395

392 Breakdown assistance
392
While the vehicle is being raised, you can
manoeuvre at a maximum speed of 40 km/h.
Before loading the vehicle, wait until transport
#
level has been reached and the
level status is shown.
%
If the vehicle is raised to transport level, the
transport settings will continue to be shown
even a er a restart. Operation of the driver's
display is meanwhile restricted.
When the vehicle is at transport level, it is lowered
again in the following situations:
When driving faster than 40 km/h.
R
The 12 V battery is discharged.
R
The vehicle is adjusted to the height of the last
active level.
T T r r anspor ansporting t ting the v
Load the vehicle onto the transporter.
#
Shi the transmission to position j.
#
Use the electric parking brake to secure the
#
vehicle against rolling away.
Switch o the vehicle and the power supply.
#
Only secure the vehicle by the wheels.
#
4MA 4MATIC v TIC vehicles ehicles
Transport
Make sure that the front and rear axles come
#
to rest on the same transportation vehicle.
he vehicle ehicle
* N N O O TE TE Damage to the drive train due to
incorrect positioning of the vehicle
Do not position the vehicle above the
#
connection point of the transport vehi-
cle.
U U nloading t nloading the v he vehicle ehicle
V V ehicles wit ehicles with AIRMA h AIRMATIC TIC
Make sure that the vehicle is raised to trans-
#
port level before unloading (
Low Lower ering t ing the v he vehicle ehicle a er a er unloading unloading
Switch on the power supply.
#
Switch on the vehicle.
#
Swipe upward in the transport settings to
#
select Standard level and press a.
The vehicle is adjusted to the height of the last
active level and the Lowering vehicle
is displayed.
A er the vehicle has been lowered, press the
#
G button for at least two seconds.
The transport settings are closed.
page 262).
/
message