Table of Contents
Advertisement
Installing a Front-Weight
Kit
For Machines with 2 or More
Accessory-Mount Kits
If 2 or more accessory-mount kits (i.e., bucket kit or
universal mount kit) are added to any of the 4 locations
shown in
Figure
15, add a front-weight kit. Contact
your Authorized Service Dealer for the front-weight kit.
Figure 15
1. Add a front-weight kit when 2 or more accessory-mount kits
are installed at these positions.
Operation
Mounting Attachments
Use only Toro-approved attachments and accessories.
The maximum capacity is 11.3 kg (25 lb).
Use the holes in the mounting brackets to secure
attachments or accessories.
Mounting a Bucket
1.
Loosen the knob and raise the top bracket.
Tighten the knob to hold it in place
2.
Place the bottom lip of the bucket over the
bottom ledge of the welded support bracket
(Figure
16).
3.
Loosen the knob and lower the top bracket as far
as possible over the rim of the bucket. Tighten
the knob
g037417
1. Knob
2. Top bracket over the rim of
the bucket
10
(Figure
16).
Figure 16
Fist clamp not shown
3. Bottom ledge of the
support bracket
(Figure
16).
g037421
Advertisement
Table of Contents
