Digital Input; Analog Input; Digital Output - Procom ECON-A Operating Instructions Manual

7. DG Voltage
8. Warning
9. Fault
6.0
If the ECON-A is switched on while the reset switch is pressed, all the LEDs start blinking till the time reset
switch is kept pressed.. This state shall persist till the switch is kept pressed and on release of the switch ECON-A
shall start functioning normally.
7.0

Digital Input

ECON-A has Eight digital input as below
Fixed Inputs
1) Remote Start,
2) Remote Stop / Semi Auto
3) Emergency
4) Magnetic Pickup unit(Not used)
Programmable 4 inputs each can be programmed as one of the following inputs.
1) RWL Switch
2) LLOP Switch
3) Fuel Switch
4) HWT Switch
5) Oil Level Switch
6) Canopy Temperature Switch
7) Oil Temperature Switch
8) HCT( High Coolant Temperature) Switch
8.0

Analog Input

ECON has three digital input :
1) Low Lube Oil Pressure Sensor
2) High Water Temperature Sensor
3) Low Fuel Level Sensor
4)
9.0

Digital Output

ECON has nine digital outputs :
• Programmable output
Three digital outputs can independently be configured for the any functions from the list below.
1) Unit Healthy
2) Load Warning
3) Fuel Pump
4) Heater/Choke
5) None
• Fixed output
Cat_ECON-06-15 -Ver1.0.
Lamp Test
This indication glows continuously when the
generator is running.
This LED blinks in case of a warning.
This LED blinks in case of a fault
Page 7/21