Redback S0080 Operating Manual page 10

50 event 24 hour 7 day timer - din rail

page of 12

/ 12
Bookmarks

Fig 3.12 illustrates the Zone Output setup procedure. There are 4 output zones to choose from. Use the up and down

buttons to change the zone output and press "Enter" when finished. The zone can also be set to "OFF" which will turn

this output off, but not affect the time settings so that it can easily be re-initiated by setting the zone output later.

The cursor is now positioned over the hour section of the Zone Duration as shown in Fig 3.13. The duration is the amount

of time the event will occur for, after the start time.

Change the hour by pressing the +10, up and down

buttons and press "Enter" when finished. The cursor

will now move to the minute section of the duration.

Repeat the above procedure to change the minutes

and press "Enter" when finished. The cursor will now

move to the seconds section of the duration. Repeat

the above procedure again to change the seconds and

press "Enter" when finished. The menu button can be

pressed at any time to exit the setup. The duration is

now set for this Station (or Event).

After completing the duration, the screen will change to

the next station ready to enter the next events details.

NOTE: IF the duration is set to 00:00:00 the zone

output will be set back to "OFF" on exiting the "Set

Duration" screen.

Redback® Proudly Made In Australia

Zone Output

Press the UP and DOWN

buttons to change the

zone output.

Enter

Press the ENTER

button to make your

selection

Press the MENU

button to exit at any

time.

1) ZONE

Enter

1) ZONE

DURATION

OFF