Advertisement
To set a Zone manually, scroll to the desired zone using the up and down buttons as shown in Fig 3.5 and then press
"Enter" when you reach your selection. When finished scroll to the "Exit Manual Zone Selection" screen and press
"Enter" or press the "Menu" button to exit at any time. (NOTE: For the unit to continue in "AUTO MODE" you must exit
back to the Main Screen.)
Manual Selection Screen
1) Manual select
of output zones
Enter
Menu
3.1.2 Add or Edit A Station Time
This option allows the user to enter the Station (Event ) information which includes the event "Turn on time", "Duration"
and "Output Zone".
If this is the first time an Event has been entered the memory will need to be "Cleared" first. To do this follow the
directions in the section "Clearing the Memory".
When powering up the unit for the first time it will be necessary to
clear the memory before entering any Station (Event) times. If this is not
done the unit will not operate correctly. To do this use option 4 in the
Navigate to the "Add or Edit a Station Time" Sub Menu as shown in Fig 3.3. If this is the first time entering this menu the
screen should appear as shown in Fig 3.6. The number "1)" shown is the Station (or Event) number which is highlighted
by a flashing cursor.
If power is removed, all outputs will switch off and all zones will
return to Auto mode once power is restored.
Enter
[AUTO]
AUTO
AUTO
Press the UP and DOWN
buttons to scroll up and
down.
[AUTO]
Press the ENTER
button to make your
selection
AUTO
Press the MENU
button to exit at any
time.
AUTO
SPECIAL NOTE FOR FIRST TIME USE:
menu. Refer to the section on "Clearing the Memory".
1)
Start @ 00:00:00
SPECIAL NOTE:
Exit Manual
Zone Selection
OUTPUT 1
ON
OFF
[AUTO]
OUTPUT 1
[ON]
OFF
AUTO
OUTPUT 1
ON
[OFF]
AUTO
OUTPUT 2
ON
OFF
[AUTO]
OUTPUT 2
[ON]
OFF
AUTO
OUTPUT 2
ON
[OFF]
AUTO
-
DAY
OUTPUT 3
ON
OFF
OUTPUT 3
[ON]
OFF
OUTPUT 3
ON
[OFF]
Fig 3.5
OUTPUT 4
ON
OFF
OUTPUT 4
[ON]
OFF
OUTPUT 4
ON
[OFF]
Fig 3.6
Redback® Proudly Made In Australia
7
Advertisement
