Panasonic DMR-EH75VP Service Manual page 41

Memory No.
(Error No.)
H01 The cylinder could not be started.
(Error of the cylinder or the cylinder driver.)
H02 The CAP FG could not be detected.
F03 Mechanism lock during without the unloading and the
cassette-up.
F04 Mechanism lock during unloading
F05 S-reel pulse cannot be detected when a cassette tape is
inserted.
(Error of the S-reel system or the Capstan system.)
F06 Mechanism lock during the Cassette-up.
F09 Communication Error between VHS Microprocessor
(IC6001) and Timer Microprocessor (IC7501)
H07 The recording circuit can not be operated in REC mode.
H08 The recording circuit is operated in except for REC mode. Yes
U11 Cylinder clogs during the PLAY mode.
F15 S-reel pulse cannot be detected when a cassette tape is
inserted.
(Error of the S-reel system or the Capstan system.)
H16 Detection of the Cylinder lock during the constant rotation No
H17 Detection of S-reel lock during the constant tape running
H18 Detection of T-reel lock during the constant tape running
F20 NG1 in the PG Shifter Automatic Adjustment
(The cylinder rotation is unstable during the automatic
adjustment.)
F21 NG2 in the PG Shifter Automatic Adjustment
(The vertical sync signal is lacked while over 5 seconds
on the alignment tape.)
F22 NG3 in the PG Shifter Automatic Adjustment
(The installing position of Heads to the cylinder is our of
specification.)
F23 NG4 in the PG Shifter Automatic Adjustment
(The servo is not locked to the cylinder for more than 10
sec.)
H80 An exceptional ejection depends on a Error
8.2.2. (VHS) Special Modes Setting
Reason
41
Automatic display
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
No
Memory
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes