Table of Contents
Advertisement
Error
Diagnosis contents
Code
H19
Inoperative fan motor
F00
No error information
F09
Serial Communication
Error between VHS
Microprocessor and
Timer Microprocessor.
F34
Initialization error
when main
microprocessor is
started up for program
recording
F58
Drive hardware error
F60
DVD module has not
been started.
Unsupported disc
UNSUPPORT
error
NO
Disc read error
READ
Description
When inoperative fan motor is
detected after powered on, the
power is turned off automatically.
The event is saved in memory.
Initial setting for error code in
memory
(Error code Initialization is
possible with error code
initialization and main unit
initialization.)
Please confirm Serial
Communication terminal of
Microprocessor.
NOTE:
If F09 appears just after updating
Firmware, pull off and insert AC
plug, then it will disappear.
When initialization error is
detected after starting up main
microprocessor for program
recording, the power is turned
off automatically.
The event is saved in memory.
When drive unit error is detected,
the event is saved in memory.
Defect of Digital P.C.B.
Mode: No change
*An unsupported format disc
was played, although the drive
starts normally.
*The data format is not
supported, although the media
type is supported.
*Exceptionally in case of the disc
is dirty.
*A disc is flawed or dirty.
*A poor quality failed to start.
*The track information could not
be read.
27
Monitor
Automatic FL
Display
No display
No display
No display
No display
No display
No display
No display
No display
No display
No display
"This disc is
incompatible."
Display for 5 seconds.
"Cannot read.
Please check
the disc."
Advertisement
Table of Contents
