Table of Contents
Advertisement
1. The indication "U" is displayed on the FIP while power remains on.
2. The indication "H" or "F" is displayed on the FIP, and the power is
automatically turned off. When the power is turned on again, the
Error indication code will disappear and the unit will return to
normal display mode (either clock or counter is displayed).
3. This Error indication code will be stored in the microprocessor
even after the AC plug being disconnected.
The two-digit number portion of the stored Error indication code
can be re-displayed in "second" display portion (the last 2 digits
of the FIP) by placing the unit is Service Mode Number 3 When
turning on Service Data Display as for example "01" or "02" etc. If
a second error occurs, the most recent error will be displayed and
stored until 3 self-diagnosis histories in maximum.
4. To erase the stored Error Code data, Press FF and EJECT buttons
on VCR simultaneously for over 5 seconds in Service Mode 3.
Error Number at a glance
40
Advertisement
Table of Contents
