Appendix A - Sending, Storing, Deleting And Recalling Test Results (Mft1835 And Mft1845+) - Megger MFT1800 Series User Manual

Appendix A – Sending, Storing, Deleting and Recalling Test Results (MFT1835 and MFT1845+)
13. Appendix A – Sending, Storing, Deleting and Recalling Test
Results (MFT1835 and MFT1845+)
Test results can be stored in the MFT, or downloaded immediately to a Bluetooth
See "11. Setup options" on page 53,
Test results are stored in "Folders" against a set of circuit references as below:
Folders:
Jb 000 to 255
Db 001 to 255
CIR 000 to 255
PHA 001 to 003
Circuit type:
In addition, the following circuit descriptors are used to identify on which part of the circuit the measurement was
made:
Insulation:
Symbol
L – E
L – N
N – E
L – L
- - -
Continuity:
Symbol
R1
R2
R12
RR1
RR2
RRN
- - -
Loop Testing:
L-E range measurements are automatically saved as L-E connections
L-N range
Symbol
L – E
L – N
L – L
RCD/GFCI:
Not relevant
Earth testing:
Earth measurements are saved under a job number only
56 MFT1800 series
Job number – Allows results from different locations to be saved in one instrument
Distribution board number
Circuit reference number
Phase number
Definition
Live to Earth Test
Live to Neutral Test
Neutral to Earth Test
Live to Live Test
No connection selected
Definition
Live
Circuit Protective Conductor
R1 + R2
Ring Circuit Phase-Phase
Ring Circuit CPC-CPC
Ring Circuit Neutral-Neutral
No connection selected
Definition
Live to Earth Test
Live to Neutral Test
Live to Live Test
® compatible device, or both.
www.megger.com