ARM DSTREAM-ST Getting Started Manual page 5

DSTREAM-ST Getting Started Guide
CE/UKCA Conformity
These marks indicate that this product meets all essential health, safety and environmental
requirements. The CE mark indicates conformity within EU member states and the UKCA mark
indicates conformity within the UK.
The Declarations of Conformity are available on request.
The Waste Electrical and Electronic Equipment (WEEE) marking, that is, the crossed out wheelie-bin
figure, indicates that this product must not be disposed of with general waste within the European
Union. To prevent possible harm to the environment from uncontrolled waste disposal, the user is
required to recycle the product responsibly to promote reuse of material resources. To comply with
EU law, you must dispose of the product in one of the following ways:
• Return it to the distributor where it was purchased. The distributor is required to arrange free
collection when requested.
• Recycle it using local WEEE recycling facilities. These facilities are now very common and might
provide free collection.
• If purchased directly from Arm, Arm provides free collection. Please e-mail
instructions.
• End-of-Life products can be disposed of safely using an Approved Authorized Treatment Facility
(AATF). To support safe disposal, Arm has partnered with B2B Compliance. B2B can be
contacted at the following weblink:
During the lifetime of the product, you are advised to:
• Inspect the product regularly to ensure that it is in good working order.
• Ensure that the product is free from dust and debris that might cause damage.
• Clean the product with an air duster when necessary.
• Power down the system when not in use.
• Observe ESD precautions when handling the product.
The product can radiate Radio Frequency Interference (RFI) or Electromagnetic Interference
(EMI) and might cause harmful interference to radio communications. There is no guarantee that
interference cannot occur in a particular installation. If you suspect that this equipment is causing
interference to other equipment, you are encouraged to try to correct the interference by one or
more of the following measures:
• Ensure attached cables do not lie across any sensitive equipment.
• Increase the distance between the product and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the product is
connected.
• Consult Arm for help.
Copyright © 2017–2019, 2022 Arm Limited (or its affiliates). All rights reserved.
https:/ /b2bcompliance.org.uk
Non-Confidential
Document ID: 100892_1.0_07_en
Version 1.0
weee@arm.com for
Page 5 of 31