The Dstream-St System; Buy Arm Dstream-St; Arm Dstream-St Box Contents - ARM DSTREAM-ST Getting Started Manual

DSTREAM-ST Getting Started Guide Document ID: 100892_1.0_07_en
Version 1.0

The DSTREAM-ST system

2. The DSTREAM-ST system
DSTREAM-ST is a debug and trace hardware unit that enables software debug and optimization on
Arm ® processor-based targets.
DSTREAM-ST provides an interface between a host such as Arm Development Studio and an Arm
processor-based target using a hardware interface such as JTAG or Serial Wire Debug (SWD). It
also enables the collection of narrow-port (4-pin) parallel streaming trace from the device for non-
intrusive debug and code optimization.
This chapter describes the DSTREAM-ST hardware.

2.1 Buy Arm DSTREAM-ST

Arm has over 100 trusted distributors around the world offering products, training, and support.
You can contact them to buy DSTREAM-ST.
For debug unit product comparisons, and more information about purchasing options, see the
Debug Probe subset of tools in the Arm Developer Store.
For OEM licenses, contact Arm directly.

2.2 Arm DSTREAM-ST box contents

The DSTREAM-ST product box contains the required components to set up and connect your PC
to your Arm ® architecture-based development board.
The items are:
• DSTREAM-ST unit.
• Power supply unit and associated cables.
• Ethernet cable.
• USB 3.0 cable.
• CoreSight ™ 10/20-way 0.05" pitch ribbon cable.
• CoreSight Short 20-way 0.05" pitch ribbon cable.
• JTAG 20-way 0.1" pitch ribbon cable.
• JTAG 14-way Texas Instruments adapter.
• MICTOR 38-way adapter.
Copyright © 2017–2019, 2022 Arm Limited (or its affiliates). All rights reserved.
Non-Confidential
Page 13 of 31