Figure 2-3: Indicator Leds - ARM DSTREAM-ST Getting Started Manual

DSTREAM-ST Getting Started Guide

Figure 2-3: Indicator LEDs

DSTREAM logo
The DSTREAM logo on the top of the unit illuminates and the STATUS LED begins to flash
when you power up the DSTREAM-ST unit. The DSTREAM logo also flashes when you
click the Identify button in the
Firmware Installer view
STATUS
Illuminates green to show that DSTREAM-ST is in its ready state.
If a critical error is detected, the STATUS LED illuminates as continuous red. If the STATUS
LED is red, then you must reset the DSTREAM-ST unit to the factory settings before you can
continue using it. If the DSTREAM-ST unit fails to boot after a reset,
For more information, see
FLASH
Illuminates when the unit is accessing its internal flash storage.
TARGET
Illuminates when a valid target VTREF is detected.
DEBUG
Illuminates when debug data transfer takes place.
Copyright © 2017–2019, 2022 Arm Limited (or its affiliates). All rights reserved.
Debug Hardware Configure IP view
in Arm Development Studio.
Restore a DSTREAM-ST
Non-Confidential
Document ID: 100892_1.0_07_en
or the Debug Hardware
contact Arm
unit.
Version 1.0
The DSTREAM-ST system
support.
Page 17 of 31