Table of Contents
Advertisement
•
Insert the connection cable of the device and screw it on.
8.
Switch the device on and off
•
When the protection cap is mounted on the Flash Light:
Remove protection cap. See Demount and mount protection cap.
WARNING! Danger of fire through heat accumulation. Never use the
device with mounted protection cap.
•
Switch on device:
Set main switch on I (ON).
•
The display lights up and shows READY when the adjusted flash output is
reached.
•
Switch off device:
Set main switch on O (OFF).
•
All displays will go out.
9.
Adjustments
9.1. Adjust flash output
You can adjust the flash output from 1/1 full output to 1/8.
B
A
A
Output controller
B
Sync socket
16
9.2. Prepare and adjust flash trigger
Prepare flash trigger through camera
ADVICE:
Please note the user information from the camera manufacturer concerning
flash synchronization.
1. Insert the snyc cord into the connection socket on the device.
2. Insert the other end of the sync cord into the X socket of your camera.
Prepare flash trigger through radio receiver (optional)
ADVICE:
Please note the user information from the radio receiver manufacturer.
Insert the cable of the radio receiver into the connection socket 3,5mm on
the device.
Put the radio transmitter on the hot shoe of your camera.
10. Trigger flash
•
Switch on device. See Switch device on and off.
•
For checking the device, trigger a flash with the test button (at Battery Pack
or radio remote release).
•
Trigger a flash according to the prepared type of flash triggering.
See Prepare and adjust flashes.
11. Transportation and storage
•
Switch off device.
See Switch the device on and off.
16 17
Advertisement
Table of Contents
