Table of Contents
Advertisement
A
B
C
D
E F
•
Open the battery compartment.
•
Pull the battery out of the Battery Pack.
•
Connect the power supply unit to the electric power supply and connect
the adapter.
Advice: Compare the local power supply with the connected load of the
device. If the values differ, please contact info@foto-walser.de or tel. +49
8432-94890.
•
Put the battery on the adapter.
•
The battery will be charged.
•
Once the battery is charged, the LED will change from red to green.
•
You can also charge the battery inside the Battery pack. For this purpose,
you have to connect the Battery Pack with the power supply unit.
A
Battery
B
Battery Pack
C
Battery
D
Adapter for battery
E
LED red/green
F
Charger
12
6.2. Flash Light RD-600
Mount and demount protection cap/reflector:
WARNING
Posterior danger of bursting of flash tube
Make sure not to touch the flash tube with bare hands accidentally.
WARNING! Danger of burning on reflector, modeling lamp and flash tube.
Let the device cool down for approx. 30 minutes.
A
B
C
•
Switch off device.
See Switch the device on and off.
•
Let the device cool down.
•
Demount protection cap/reflector.
•
Push back unlocking lever and keep pressed.
•
Plug the reflector into the three openings, so that the opening for the
reflex umbrella (optional) faces downwards.
•
Turn the reflector clockwise and listen for the reflector to snap into place.
•
Release the unlocking lever.
•
Stick the safety cap onto the unlocking lever.
Demount protection cap/reflector:
•
Push back unlocking lever and keep pressed.
A
Openings for reflector or protection cap
B
Unlocking lever
C
Tripod mount
13
Advertisement
Table of Contents
