Accessories And Options; Spare Parts; Disposal And Environment Protection - walimex RD-600 Instruction Manual

Part of the device
Housing
Modeling lamp, flash
tube
Reflector
13.3. Change micro-fuse
WARNING
Danger of electric shock and fire through short-circuit
A micro-fuse, which is not conform with the required specifications, doesn´t
protect against the overloading of the device.
Please just use a micro-fuse, which is conform with the required
specifications. See Technical Specifications.
•
Switch off device.
See Switch the device on and off.
•
Disconnect from power supply:
Unplug power supply unit/battery.
•
Open fuse holder:
Use a small screwdriver to lift up the fuse holder carefully and slightly.
20
Cleaning
Use a microfiber cloth to remove light and
stubborn dirt
Wipe off with dust brush or dry, soft cloth
ADVICE:
Don´t clean the modeling bulb and flash tube
with water. Even small residues on the bulb
could lead to bursting.
Remove dirt with microfiber cloth
A
•
Pull out the fuse holder completely out of the slot.
•
Take out the old micro-fuse.
•
Slide the new micro-fuse carefully into the slot and turn it with a
screwdriver clockwise.

14. Accessories and options

You can find extensive accessories for your walimex pro device in our
webshop.

15. Spare parts

Part of the device
Additional battery for Battery Pack RD-600
Standard Reflector

16. Disposal and environment protection

Your device should be disposed free of charge at the local disposal points.
Pay attention to the disposal of the battery.
A Fuse holder
Item number
16700
16701
21